My circuit is FOLDED CASCODE AMPLIFIER WHICH IS AN ANALOG CIRCUIT.
AS I HAVE SUCCESSFULLY COMPLETED MY STAGE 1
IN THE STAGE 2 I HAVE AN ERROR IN THE WAVEFORM 
AS THE OUTPUT OF MY FOLDED CASCODE AMPLIFIER IS A SINE WAVE
BUT I GOT A STRAIGHT LINE FROM ORIGIN TO SOME OTHER POINT
WHILE I WAS DOING IN ESIM I HAVE NO PROBLEM BUT COMING TO SKYWATER130 
I HAVE A PROBLEM WITH THE CHANGE IN THE WIDTH.

Procedure:
1. Open the esim
2. Actually we have to open the new project but for me i did my project New Subcircuit naming it as exp1.
3. After that i placed all the components that i needed by watching 10-bit DAC Course.
4. Wired all the components
5. Given Vdd and Gnd
6. Taken ports for all the DC Components
7. By selecting place net name-local label given all the names to the nets
8. By clicking on "e" edited the names of all the components placed on the board.
9. Annotate schematic components
10. Performed electric rules check
11. Generate Netlist--spice--default format--generate
12. save the location of the file and then close 
13. .CIR file is generated
14. Copy the CIR file and paste it in the skywater130_fd_pr
15. Open the CIR file pasted in the Skywater130_fd_pr with notepad
16. Change the modifications that are needed
17. Run the CIR file
18. I faced few errors like not finding the path
		            unknown circuit....
19. Finally i got the output as a straight line but my actual output is a sine wave
